Concrete Contractors in Pinehurst, NC

Concrete contractors in Pinehurst answer to a Village, not a town

Under North Carolina law Pinehurst is a Village in Moore County, and the Village of Pinehurst Planning and Inspections Department runs the permit desk. Applications, payments and inspection requests all go through its online Permit Center. Its permit list names patios and driveways outright. Any fence, wall or retaining wall over 18 inches tall is on there too.

A brand new driveway needs a permit. So does a new entrance, a wider apron or a changed apron material. A new or expanded patio, walkway or terrace needs one as well, and the Village counts concrete, gravel and pavers alike. Start with the Village's building permit page, then call us for the pour. Our permits guide covers the rest of the region. Here we stick to what changes inside the Village limits.

Patio permit, driveway permit: how the Village splits them

Say you want a new rear patio and a wider driveway apron. Concrete patio installation in Pinehurst starts with the patio permit, and the apron needs its own. If you hire concrete contractors in Pinehurst for both, expect two applications. The Village's which-permit guide puts it this way: the patio permit covers a "new or expansion of patio, walkway, terrace etc." and counts gravel, paver and concrete alike. The driveway permit covers a brand new driveway, a second entrance, widening, and changing the apron material.

Swapping the driveway surface is the exception. Leave the apron alone and keep the same footprint, and the guide says the driveway permit isn't required. When you file, the driveway application asks for the apron type (asphalt or concrete), pipe and riprap, the existing and proposed impervious percentage, the zoning district and a site plan. The Village wants 48 hours of notice for the final driveway inspection, so we set your pour date with that visit in mind.

The same form lists other approvals that can apply: a Floodplain Development Permit in a flood zone, a Certificate of Appropriateness in the historic overlay, an NCDOT permit on a state road, and a Right of Way Encroachment agreement. The Village posts its current fee schedule, so check that before you budget. We'll tell you at the free estimate which of those your lot touches.

How much concrete your Pinehurst lot is allowed to hold

Section 9.2 of the Pinehurst Development Ordinance caps the share of a lot that can be covered by impervious surface, and the cap changes by zoning district: 24 percent in R-210, 30 in R-30, 35 in R-20, 37.5 in R-15, 40 in R-10, 42.5 in R-8 and 45 in R-5. The Village's FAQ is blunt about what counts. Buildings, driveways, walkways, patios and concrete or gravel surfaces are all impervious, and decks are not. To get your percentage, divide total impervious square feet by lot square feet and multiply by 100.

Run it on a real lot. A 20,000 square foot lot in R-20 can carry 7,000 square feet of roof, driveway, walks and patio combined. Once the house, garage and driveway are counted, the patio you sketched may be the last piece that fits. Bring your district's dimensional table and a copy of your survey to the estimate, and our concrete contractors in Pinehurst will run your number. The ordinance also warns that state watershed rules can set lower limits. R-8 carries a footnote too: a new single-story home up to 2,400 square feet under roof is allowed, but then the only other impervious surface is a driveway no wider than 18 feet, a direct walk to the front door and a patio of 64 square feet at most. Better to learn that before the forms go up.

Historic district blocks: earth-tone color and a Certificate of Appropriateness

Pinehurst has a Local Historic Overlay District created by Village Council in 2006, with its own seven-member Historic Preservation Commission. It is separate from the National Historic Landmark district designated in 1996, and the local district reaches streets outside the landmark boundary. The Village says to check its Local Historic District map to see whether your address is inside.

If it is, the Historic District Standards treat new parking areas, walks and driveways as Minor Work. Rear-yard decks and patios fall under it too. Minor Work needs a Certificate of Appropriateness from the Village Planner before you pour. The standards say a concrete driveway should use "earth-tone tints or coloring that blends with the natural environment," that new driveways should disturb landscaping and walkways as little as possible, and that existing brick and stone pavers should be preserved. Removing a street-side tree 12 inches or larger across is Major Work.

A decorative stamped rear patio is Minor Work too, so it goes through the same Certificate. Stamped concrete installation in Pinehurst's historic blocks starts there. The earth-tone wording is written for driveways, but a patio that matches the driveway looks right on a historic lot, so we talk color at the estimate and can pick integral color and release from the earth-tone end of the chart for stamped work in Pinehurst, and our stamped versus pavers guide helps you weigh concrete against pavers for a historic frontage.

Candor sand and fragipan loam under the forms

The USDA soil survey, read at forty random points inside the Census place boundary, shows Candor sand or Candor-Urban land complex at 25 of them, about 62 percent, and Vaucluse loamy sand at 9. NRCS rates Candor as somewhat excessively drained and puts it in hydrologic group A, a deep sandy Coastal Plain soil. Vaucluse is well drained but sits in group C, with a fragipan layer that slows water below the surface.

On deep sand, water leaves fast and the ground doesn't hold a firm edge, so we spend the pre-pour hours on compaction and on where the roof water lands. Edges and downspout spots wash out first. Vaucluse lots flip the problem, so we watch for water lingering on the layer below. The same sample found one point in frequently flooded Bibb loam, and FEMA's flood layer put 4 of 40 points in Zone AE or a floodway. That's a rough sample and settles nothing about your address, so look yours up on the state flood risk lookup.

Whatever your soil map says, slab thickness and the compaction plan go in your written estimate. Our slab page for Pinehurst covers that spec.

Golf course and lakefront edges, sheds, and walls over 18 inches

A lot beside a fairway or a lake carries extra rules. The Village requires accessory structures and fences to sit 30 feet back from a golf course or lakefront property line, and fences are not allowed in that setback at all. If you're planning a pad for a shed or a workshop, remember that Pinehurst limits sheds to 12 feet in any dimension, one per property, in the rear yard and 5 feet off the lines. A 12 by 12 pad is 144 square feet, so size the slab to the shed.

Walls get their own trigger. A retaining wall over 18 inches tall is on the Village's permit list, so a sloped backyard starts with the permit conversation and then a plan. Price ranges are on our retaining wall page for Pinehurst. Trees count too. Removing one in the Village right-of-way needs approval from Public Services, and the Village says extensive grading may need a development permit. We stake the pour area before anyone moves dirt.

What a Pinehurst patio or driveway runs

The median home in the Village was built in 1995, and the 2020 to 2024 Census survey puts the median home value at $476,600, so half the homes date to 1995 or earlier. Here is what we charge as concrete contractors in Pinehurst. Patios, slabs and driveways run $7 to $12 per square foot, and stamped work runs $12 to $20 per square foot, always confirmed in a free written estimate after we see the site.

Try it on your footprint. A 14 by 20 patio is 280 square feet, so plain concrete lands at $1,960 to $3,360 and a stamped one at $3,360 to $5,600. A 24 by 30 driveway is 720 square feet, or $5,040 to $8,640, and tearing out the old one adds $1.50 to $4 per square foot. Our patio page and driveway page for the Village break those jobs down further, and the driveway cost guide shows what moves the number. If you may add to the yard later, say so at the estimate and we'll leave room in the layout and the coverage number.

Resort-quality finish for Pinehurst driveways and patios

A Pinehurst street is part of the picture, so the concrete in front of the house gets looked at. You can ask for a stamped driveway in an ashlar slate or flagstone pattern, an exposed-aggregate walk to the front door, or a colored patio that sits well with the landscaping around it. We pour all of those. A resort-quality result starts under the surface: well-set forms, a clean grade and a sealer that goes on at the right time, so the color and pattern still read well years later.

• Stamped and colored driveways for homes near the resort
• Patios with borders, mixed patterns and more than one color
• Exposed-aggregate and broom-finish walkways

Stamped work runs $12 to $20 per square foot, and we write the number after we walk your lot. Inside the historic district, a driveway's color has to fit the Village's earth-tone rule, so pick it with the standards in hand.

Booking concrete contractors in Pinehurst for your lot

Before you call, find your survey or plot plan and your zoning district on the Village's map, and snap a photo of where the driveway meets the street. With those we can tell you in one visit whether you need a patio permit, a driveway permit, a Certificate of Appropriateness, or all three, and what the lot-coverage math allows.

The estimate is free and written, and it lists the Village steps that apply to your job. If you've talked to concrete contractors in Pinehurst before and heard "we'll see what the Village says," you'll get the Village steps in writing from us instead. We pour in Southern Pines, which borders the Village, and across the area from Sanford in Lee County and Lillington in Harnett County to Spring Lake and the neighborhoods around Fort Bragg. See every service on the service area page or call (910) 996-0343.