Garage, shop and pole barn slabs: what each floor needs
If you typed someone to lay slabs near me, start with what the floor will carry. A garage floor takes cars and the odd oil drip. A shop floor takes a lift, a welder or a bench of tools. A pole barn floor takes a tractor or a stack of pallets. Each one wants its own thickness, finish and edges, so the first thing we ask is what the floor will hold.
The NC Residential Code sets the minimums for a residential pour. Slab-on-ground floors must be at least 3 1/2 inches thick under R506.1, and garage floors exposed to weather call for 3,000 psi with 5 to 7 percent entrained air. An interior floor inside a heated house calls for 2,500 psi. A garage that must hold a loaded truck, a boat trailer or a lift gets a thicker design than the minimum, and we spell the thickness out in the estimate.
Pricing a residential concrete garage slab with any company? Ask for the lines separately. We quote our garage slab services that way, so you can see what you're paying for.
The 12-foot line: when the building on your slab needs a permit
The City of Fayetteville's Development Guide puts a building permit on a new accessory building with any side longer than 12 feet. A 10x12 shed stays under that line. A 16x20 workshop or a 24x30 garage does not. That same list also covers additions, carports, storage buildings and demolition over 150 sq ft. The guide's list doesn't name ground-level pads on their own, but yours will sit under a building, so call city Permitting and Inspections before you order a truck.
Outside the city, the office changes. Hope Mills and Spring Lake inspect inside town limits, and unincorporated Cumberland County uses its own Planning and Inspections. Hoke County, Harnett County and the others each run a permit counter, and the county permit guide lines them up. A barn floor outside the city can land at a different desk than a garage inside it.
Pole barn concrete floor work in the rural parts of Cumberland, Hoke and Harnett counties follows the same logic. A concrete slab contractor in Fayetteville prices a barn floor after learning who permits it.
Concrete slab contractors in Fayetteville price by the square foot, and ours runs $7 to $12 for garage and shop floors, which puts a 20x20 to 24x24 slab at $2,800 to $6,900. Smaller shed pads can hit a job minimum.
| Slab | Size | Per sq ft | What it comes to |
|---|---|---|---|
| Shed or workshop pad | 20x20 (400 sq ft) | $7 to $12 | $2,800 to $4,800 |
| Two-car garage slab | 24x24 (576 sq ft) | $7 to $12 | $4,032 to $6,912 |
| Garage and storage bay | 24x30 (720 sq ft) | $7 to $12 | $5,040 to $8,640 |
| Shop floor or small barn | 30x40 (1,200 sq ft) | $7 to $12 | $8,400 to $14,400 |
| Typical garage range | 20x20 to 24x24 | $7 to $12 | $2,800 to $6,900 |
Square-foot math for a 4-inch reinforced slab. A thicker design for heavy loads, fill depth, truck access and the plumbing and power layout move the number. We give a free written estimate after we see the site.




